projekte:minifraese:protocol_frame
Inhaltsverzeichnis
Frame built
Lower Frame
- - We tap holes with the taps into alu-extrusions to merge it with 3d printed mcs I-connertors (60×60) and endkappe„.
- - We connect two horizontal extrusions with other two and screw mcs winkel-stabil (40×20) together.
- - We add angle connectors (mcs_winkel_stabil_40x20) to support the new struts
- - We connect third horizontal bar to the just build rectangle 120mm from the rear horizontal extrusion using angle connectors (mcs_winkel_stabil_40x20)
- - We add end covers (mcs_endkappe_40x20) to the sides of the foremost and hindmost extrusions
Vertical Frame
- combine 3 extrusion (300mm) to form a „U“-Form using angle connectors (mcs_winkel_stabil_40x20)
- reinforce using corner connectors (mcs_l-verbinder_stabil_60x60)
- add end covers (mcs_endkappe_60x20) to the „bottom“ of the „U“
Connect everything
- connect the vertical frame (invert the „U“) with the lower frame using cube connectors (mcs_wuerfelverbinder_20x20)
- add angle connectors (mcs_winkel_stabil_40x20) to strengthen the connection between the long struts (400mm) and the vertical frames „legs“
- add corner connectors (mcs_l-verbinder_stabil_60x60) to finalize
projekte/minifraese/protocol_frame.txt · Zuletzt geändert: 2015/11/27 23:22 von 127.0.0.1