projekte:minifraese:protocol_frame
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen RevisionVorhergehende Überarbeitung | Letzte ÜberarbeitungBeide Seiten der Revision | ||
projekte:minifraese:protocol_frame [2015/11/05 22:31] – exoplanet | projekte:minifraese:protocol_frame [2015/11/05 22:31] – [Lower Frame] exoplanet | ||
---|---|---|---|
Zeile 3: | Zeile 3: | ||
==== Lower Frame ==== | ==== Lower Frame ==== | ||
- | - We tap holes with the taps into alu-extrusions to merge it with 3d printed mcs I-connertors (60x60) and endkappe" | + | |
- | - We connect two horizontal extrusions with other two and screw mcs winkel-stabil (40x20) together. | + | |
- | - We add angle connectors (mcs_winkel_stabil_40x20) to support the new struts | + | |
- | - We connect third horizontal bar to the just build rectangle 120mm from the rear horizontal extrusion using angle connectors (mcs_winkel_stabil_40x20) | + | |
- | - We add end covers (mcs_endkappe_40x20) to the sides of the foremost and hindmost extrusions | + | |
+ | | ||
==== Vertical Frame ==== | ==== Vertical Frame ==== | ||
projekte/minifraese/protocol_frame.txt · Zuletzt geändert: 2015/11/27 23:22 von 127.0.0.1