projekte:minifraese:protocol_frame
Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Nächste Überarbeitung | Vorhergehende Überarbeitung | ||
| projekte:minifraese:protocol_frame [2015/11/05 22:24] – angelegt exoplanet | projekte:minifraese:protocol_frame [2015/11/27 23:22] (aktuell) – Externe Bearbeitung 127.0.0.1 | ||
|---|---|---|---|
| Zeile 1: | Zeile 1: | ||
| **Frame built** | **Frame built** | ||
| - | 1. We tap holes with the taps into alu-extrusions to merge it with 3d printed mcs I-connertors (60x60) and endkappe" | + | ==== Lower Frame ==== |
| - | 2. We connect two horizontal extrusions with other two and screw mcs winkel-stabil (40x20) together. | + | |
| - | 3. We add angle connectors (mcs_winkel_stabil_40x20) to support the new struts | + | - - We tap holes with the taps into alu-extrusions to merge it with 3d printed mcs I-connertors (60x60) and endkappe" |
| - | 4. We connect third horizontal bar to the just build rectangle 120mm from the rear horizontal extrusion using angle connectors (mcs_winkel_stabil_40x20) | + | |
| - | 5. We add end covers (mcs_endkappe_40x20) to the sides of the foremost and hindmost extrusions | + | |
| + | | ||
| + | | ||
| + | - | ||
| + | ==== Vertical Frame ==== | ||
| + | |||
| + | - combine 3 extrusion (300mm) to form a " | ||
| + | - reinforce using corner connectors (mcs_l-verbinder_stabil_60x60) | ||
| + | - add end covers (mcs_endkappe_60x20) to the " | ||
| + | |||
| + | ==== Connect everything ==== | ||
| + | |||
| + | - connect the vertical frame (invert the " | ||
| + | - add angle connectors (mcs_winkel_stabil_40x20) to strengthen the connection between the long struts (400mm) and the vertical frames " | ||
| + | - add corner connectors (mcs_l-verbinder_stabil_60x60) to finalize | ||
projekte/minifraese/protocol_frame.1446758676.txt.gz · Zuletzt geändert: 2015/11/27 23:16 (Externe Bearbeitung)